Product List
Home » Products » Roll Forming Machine » Flat Sheet Roll Forming Machine

Flat Sheet Roll Forming Machine

Flat Sheet Roll Forming Machine
Main parameter
De-coiler passively de-coiling
Load-bearing of de-coiler 5 T
Frame of machine welded with 350H beam steel
Thickness of wallboard 18mm
Guide feeding way of forming side direction roller type
Forming machine type wallboard and chain drive
Diameter of shaft ￠70mm
Chain 16A single row
Motor power of forming machine 5.5KW
Line speed of forming machine 10-15m/min
Steps of forming machine 18
Roller material superior 45# steel forging
Thickness of Chrome plated on roller 0.05mm
Hydraulic station motor 4 KW, pressure: 8-12Mpa
Hydraulic station oil pump gear pump
Cutting blade material 16.Cr12
Cutting blade heat treatment 17. HRC58º-60
Rolling thickness 0.3-0.8 mm
Feeding width 1000mm
Precision of cut-to-length 20.±2mm
Electrical control system Computer adopts PLC (Panasonic)
Voltage 380V, 50Hz, 3 Phases
Profile drawing:

Technological process:
Passively de-coiling → Guiding & Feeding material → Roll Forming → Cutting-to-length → Output panel

Equipment configuration
Normal manual De-coiler (5T); Main machine of roll forming; Hydraulic forming cutting; Hydraulic station; PLC computer operation cabinet; Run-out table

Related products
  • Flattening Rectifying Deviation Device Short introduction rollers working, servo automatic sizing, worm and gear adjust the leveled plate thickness.
    Function: The clearances of up and down rollers can be adjusted by the upper hand-wheel while figure can be shown by dial indicator. The operation linear speed is adjusted step-less. It can be controlled by the signal of mid-bridge for high and low speed change...
  • 914-610 Arch Sheet Roll Forming MachineMain Technical Specifications of 914-610 Arch Sheet Roll Forming Machine:
    Size: 11200mm × 2230mm × 2300mm.Total Weight: about 15000KG
    Total MotorPower:17.9KW
    Bending Power: 3.0kw+1.1kw×2 Seaming Power: 2.2kw....
  • Double Sheet Forming Machine 1.De-coiler: manual operation, passively de-coiling
    2. Loading of de-coiler: 5 T
    3. Frame of machine: welded with 350H beam steel
    4. Thickness of wallboard: 16mm....
  • Lipp-SM40 Spiral Steel Silo Forming Machine1. Rx4.0m/m steel strip forming merging and suturing machine is a new type of circular steel plate machine in our company. Developed from Germany LIPP-SM40 forming machine, it is an innovative product, which owns the same functions but takes less installation time and cost. 2. Rx4.0m/m steel strip forming machine adopts high-strength alloy structural steel, which can greatly improve the service life. Besides...
  • Lifting MachineWe are professinal manufacture of building machine. Our main products are: PRO-240/PRO-120 Arch sheet roll forming machine, Multi-shape Building Machine, Screw-jointed Equipment, Span Arch Sheet Project, MSBM Project, Screw-jointed Project, KR 18 Roll Forming Machine,Glazed Tile Roll Forming Machine, Double Layer Roll Forming Machine, 840 Corrugated Sheet Roll Forming Machine,Corrugated Roof  ...